[3dprinting] Re: Cura-Lulzbot update

On Thu, 2018-04-19 at 16:32 -0400, Tom Callaway wrote:

On 04/19/2018 12:45 PM, Simo Sorce wrote:

...

Nevermind, after updating the firmware it started working again, weird that though, the older cura had no problem, but even downgrading to the cura-lulzbot released at F27 GA I was not able to talk to the printer anymore ...

Yeah, there is a firmware incompatibility with the latest stuff. Should hopefully be a one-time thing.

It would be nice if the pop-up error could hint at upgrading the firmware as something the user may want to look at if they think the error message is "wrong".

Simo.