Hi! While theoretically should be possible, i would like to hear some
confirmation that f33 can work on odroid N2 ...
Moreover, if it can work, all i have to do is to write the image on
eMMC, isn't it?
Disclaimer: it's my first time playing in arm world, so many things are
strange to me..
Thanks a lot!!
I am trying to update the SPI on a Pine64 Rockpro64. I have flashed the
SPI with ayufan's uboot, Debian starts. Now I want to flash the SPI with
Fedora's uboot. Here are the steps to load the Fedora uboot on the SPI:
- I made the microSD using the arm-image-installer,
- loaded the microSD in the RockPro,
- entered the command sf probe in the u-boot prompt,
- receive the message
Invalid bus 0 (err=-19)
Failed to initialize SPI flash at 0:0 (error -19).
I have tried the erase firmware available from ayufan's repository and
have the same outcome.
Am I grounding the SPI pin too long? Do I need to compile the firmware
with extra config?
I currently have a Raspberry Pi 3 and am looking at an upgrade. The
Pi 4 does’t support Fedora well, so I would like suggestions for a
similar device with good support. Working wifi and video are the key
things I want along with the ability to run 32 and 64-bit kernels.
Just a heads up for those that have a brcmfmac, the Cypress variants
of these WiFi modules (there's 3 vendors that make them: Broadcom,
Cypress/Infineon and now Synaptics) have got new firmwares, I'm giving
a heads up because in some cases the firmwares are being updated from
firmwares that date back to 2014 so no doubt there's quite some
If you run into a problem just report it in bugzilla in the usual manner.
On the plus side there's at least one CVE I'm aware of and for some of
the older firmwares I've little doubt there's quite a few more.