Ext2ls and the usb start commands are built into uboot. You need to be at the uboot prompt to use them.
----- Reply message -----
From: "Robert Moskowitz" <rgm@htt-consult.com>
To: "Paul Whalen" <pwhalen@redhat.com>
Cc: <arm@lists.fedoraproject.org>
Subject: [fedora-arm] Bad image/instructions? - Re: Problems with a pogoplug v02
Date: Thu, Apr 18, 2013 4:19 pm
On 04/18/2013 03:11 PM, Paul Whalen wrote:
>
> ----- Original Message -----
>> Per:
>>
>> fedoraproject.org/wiki/Architectures/ARM/F18/GuruPlug
>>
>> I just downloaded the image again from:
>>
>> http://dl.fedoraproject.org/pub/fedora-secondary/releases/18/Images/arm/Fedora-18-kirkwood-arm.img.xz
>>
>> This time I took a 4Gb usb drive I got from MicroCenter that still had a
>> FAT partition. On my F18 notebook as root, I ran:
>>
>> xzcat Fedora-18-kirkwood-arm.img.xz > /dev/sdc1
> Hi Rob,
>
> In your above example your writing to the first partition. Try changing that to:
>
> xzcat Fedora-18-kirkwood-arm.img.xz > /dev/sdc
>
> Hope that works,
OK. I kind of figured out part of this. That is, I had more to do
after the 1st boot, per:
fedoraproject.org/wiki/Architectures/ARM/F18/GuruPlug
Problem is with the instructions:
# NOTE: substitute "usb 1:1" with "usb 0:1" on non-Plus model devices,
or try:
usb start
ext2ls usb x:1
#where x can be any integer but usually 0-3, the right number will show
a directory listing including the files uInitrd and uImage
Well no usb or ext2ls commands. I searched all over the image. I ran
updatedb, the tried locate. Nothing. Now what?
_______________________________________________
arm mailing list
arm@lists.fedoraproject.org
https://admin.fedoraproject.org/mailman/listinfo/arm