On Thu, April 16, 2020 10:01 am, Peter Robinson wrote:
>
> So where is this Rev B1 coming from? Why does it not know it's a Rev D1
> board? This is clearly causing it to pull in the wrong DTB file, which
> explains why it isn't working.
It's the last option in the statement check in board detection which
means it's basically the board of last resort. so it seems your rev of
the D1 isn't being detected, there was initial support for the revD1
land upstream in U-Boot in Oct 2017.
*sigh* I acquired this board only a few months ago.
I tried doing a "setenv" within uboot to change the board-name from B1 to
D1 but obviously that didn't do anything since I think it needs to be
detected earlier than that. So this requires a change to u-boot? I must
admit that I've never looked at uboot code so not even sure where to start
to see where I would need to add something for my board, let along figure
out what it is I need to add. (Well, I suppose once I figure out what
it's looking for I can hopefully probe the board to figure out what it's
saying).
Why can't they make this easy? :(
-derek
--
Derek Atkins 617-623-3745
derek(a)ihtfp.com
www.ihtfp.com
Computer and Internet Security Consultant