Hello everyone, I tried installing the Fedora 13 beta in the Beagleboard xm board using these instructions: http://fedoraproject.org/wiki/Architectures/ARM/BeagleBoardxMSDCard with the latest kernel and modules from: http://www.angstrom-distribution.org/demo/beagleboard/ The board boots but I receive the following kernel panic during start up: Kernel panic - not syncing: Attempted to kill init! Here's the last few output lines from the serial port before this message: [ 14.928527] Console: switching to colour frame buffer device 80x30 [ 14.951416] regulator_init_complete: incomplete constraint s, leaving VAUX3 on [ 14.958923] regulator_init_complete: incomplete constraints, leaving VDAC on [ 14.966552] omap_vout omap_vout: probed for an unknown device [ 14.972839] Waiting for root device /dev/mmcblk0p2... [ 14.978485] usb 2-2: New USB device found, idVendor=0424, idProduct=9514 [ 14.986145] usb 2-2: New USB device strings: Mfr=0, Product=0, SerialNumber=0 [ 14.995910] hub 2-2:1.0: USB hub found [ 14.999847] hub 2-2:1.0: 5 ports detected [ 15.086975] mmc0: new high speed SDHC card at address 1234 [ 15.092926] mmcblk0: mmc0:1234 SA04G 3.67 GiB [ 15.097778] mmcblk0: p1 p2 [ 15.203521] kjournald starting. Commit interval 5 seconds [ 15.213500] EXT3-fs (mmcblk0p2): using internal journal [ 15.218811] EXT3-fs (mmcblk0p2): recovery complete [ 15.223724] EXT3-fs (mmcblk0p2): mounted filesystem with writeback data mode [ 15.230926] VFS: Mounted root (ext3 filesystem) on device 179:2. [ 15.241882] devtmpfs: mounted [ 15.244964] Freeing init memory: 204K [ 15.288787] Kernel panic - not syncing: Attempted to kill init! Please let me know if you have any suggestions or need any additional information. Thanks! Regards, Ismael -- Ismael Schinca Centro Ceibal - Depto. Técnico - I+D Avda. Italia 6201 - Edificio Los Ceibos Montevideo - Uruguay. Tel.: 2601 57 73 Int. 2232