On Fri, Sep 22, 2017 at 8:55 PM, Davi Garcia davivcgarcia@gmail.com wrote:

Hi all,

I'm trying to use the latest Fedora ARM Minimal image (26-1.5) with my RPi2 but it gets stuck at rainbow screen. I tested the same device, with the same sdcard and power supply, but with Raspibian and the problem doesn't happen.

I'm using the following CLI to burn the image:

# fedora-arm-image-installer --image=Fedora.xz --target=rpi2 --media=/dev/mmcblk0

Any advice?

The rainbow screen indicates a couple of things, a non bootable image, a not powerful enough PSU (what amps is it?) or not a RPi 2/3 (what is the version number on the circuit board?).

Peter

On Sat, Sep 23, 2017 at 1:12 AM, Davi Garcia davivcgarcia@gmail.com wrote:

Hi Peter,

Thanks for your reply!

I already tested with different 2A power sources, so I'm sure that this was not the problem. But I just discovered the issue... I was using my old RPi B+ and not my RPi2 (facepalm)!

That was actually my first guess ;-)

Regards, Davi Garcia

On Fri, Sep 22, 2017 at 6:23 PM, Peter Robinson pbrobinson@gmail.com wrote:

...

On Fri, Sep 22, 2017 at 8:55 PM, Davi Garcia davivcgarcia@gmail.com wrote:

...

Hi all,

I'm trying to use the latest Fedora ARM Minimal image (26-1.5) with my RPi2 but it gets stuck at rainbow screen. I tested the same device, with the same sdcard and power supply, but with Raspibian and the problem doesn't happen.

I'm using the following CLI to burn the image:

# fedora-arm-image-installer --image=Fedora.xz --target=rpi2 --media=/dev/mmcblk0

Any advice?

The rainbow screen indicates a couple of things, a non bootable image, a not powerful enough PSU (what amps is it?) or not a RPi 2/3 (what is the version number on the circuit board?).

Peter