When a remote dump target is specified, kdump dracut module prefixes
'kdump-' to network interface name (ifname) as kernel assigned names
are not persistent. In fadump mode, kdump dracut module is added to
the default initrd, which adds the 'kdump-' prefix to the ifname of
the prodcution kernel itself. If fadump mode is disabled after this,
kdump dracut module picks the ifname that is already prefixed with
'kdump-' in the production kernel and adds another 'kdump-' to it,
making the ifname something like kdump-kdump-eth0 for kdump kernel.
Eventually, kdump kernel fails with below traces:
dracut-initqueue[246]: RTNETLINK answers: Network is unreachable
dracut-initqueue[246]: arping: Device kdump-kdump-eth0 not available.
The ip command shows the below:
kdump:/# ip addr show kdump-kdump-eth0
2: kdump-kdump-eth: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 \
qdisc pfifo_fast state UNKNOWN qlen 1000
link/ether 22:82:87:7b:98:02 brd ff:ff:ff:ff:ff:ff
inet6 2002:903:15f:550:2082:87ff:fe7b:9802/64 scope global \
mngtmpaddr dynamic
valid_lft 2591890sec preferred_lft 604690sec
inet6 fe80::2082:87ff:fe7b:9802/64 scope link
valid_lft forever preferred_lft forever
kdump:/#
The trailing 0 from kdump-kdump-eth0 is missing in the ifname, probably
truncated while setting.
This patch fixes this by avoiding addition of the prefix 'kdump-' when
such prefix is already present in the ifname.
Signed-off-by: Hari Bathini <hbathini(a)linux.vnet.ibm.com>
---
* No changes from v1.
dracut-module-setup.sh | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/dracut-module-setup.sh b/dracut-module-setup.sh
index 68e0ff8..490501a 100755
--- a/dracut-module-setup.sh
+++ b/dracut-module-setup.sh
@@ -161,7 +161,8 @@ kdump_get_perm_addr() {
kdump_setup_ifname() {
local _ifname
- if [[ $1 =~ eth* ]]; then
+ # If ifname has 'kdump-' prefix, don't add it again
+ if [[ $1 =~ eth* ]] && [[ ! $1 =~ ^kdump-* ]]; then
_ifname="kdump-$1"
else
_ifname="$1"
Show replies by thread