RTC setup question
by Banasek, Jacob Thomas
I just found this software and trying to connect on the BeamConstruct software to an RTC 3 card. I think I have it set up to the correct files (and have tried many different things), but am continually getting "cannot allocate required resources" as an error whenever I try to run a pattern. I think it is connection to the software problem as this card does work with a different program that was being used). I was wondering if anyone had any tips, tricks, or suggestion on how to get this to work.
thanks for your time and help
jacob
11 years, 2 months
120804 No Ether Dream action?
by Frank
Gentlemen,
I am trying to connect and update an Ether Dream card using the EdWatcher
utility. When the card is connected via Ethernet port, EDwatcher does not
report any statistics (MAC, SW rev, etc.), and when I load the 1_04 firmware
update and hit "start update" via USB, I get the error screen saying device
not found! I went to the Ether Dream site and managed to run the
<http://www.ether-dream.com/update-v0.4.3.exe> update-v0.4.3.exe program,
which apparently worked (as evidenced by the LED actions). I am pulling my
hair out, anybody have any suggestions how I can get this card recognized by
EDWatcher?
Kind Regards,
Description: Frank
Frank Bradford
frank(a)bradford1.com
11 years, 7 months