4:23 p.m.
I have a unit test that is failing to run under Rake when it runs with
all unit tests. But if I run it by itself using either "rake test
TEST=path/to/file" or else run it with ruby using "ruby path/to/file" it
passes every time.
The failure is caused by the setup method not being invoked before each
test, but only for that one class. The setup method in other classes run
fine, and in this class as well when it runs by itself.
Any suggestions or ideas for what to look at?
--
Darryl L. Pierce, Sr. Software Engineer @ Red Hat, Inc.
Delivering value year after year.
Red Hat ranks #1 in value among software vendors.
http://www.redhat.com/promo/vendor/
12:42 a.m.
On 09/08/2011 11:23 PM, Darryl L. Pierce wrote:
I have a unit test that is failing to run under Rake when it runs
with
all unit tests. But if I run it by itself using either "rake test
TEST=path/to/file" or else run it with ruby using "ruby path/to/file" it
passes every time.
The failure is caused by the setup method not being invoked before each
test, but only for that one class. The setup method in other classes run
fine, and in this class as well when it runs by itself.
Any suggestions or ideas for what to look at?
Another test run before it likely breaks this test. Purely out of
curiosity, can you figure out the test that causes it to break, take
that and the test that is being broken, and then create the smallest
possible test suite that also breaks in a similar way (and post it here)?
7:29 a.m.
On Fri, Sep 09, 2011 at 07:42:44AM +0200, Emanuel Rietveld wrote:
On 09/08/2011 11:23 PM, Darryl L. Pierce wrote:
> I have a unit test that is failing to run under Rake when it runs with
> all unit tests. But if I run it by itself using either "rake test
> TEST=path/to/file" or else run it with ruby using "ruby path/to/file"
it
> passes every time.
>
> The failure is caused by the setup method not being invoked before each
> test, but only for that one class. The setup method in other classes run
> fine, and in this class as well when it runs by itself.
>
> Any suggestions or ideas for what to look at?
Another test run before it likely breaks this test. Purely out of
curiosity, can you figure out the test that causes it to break, take
that and the test that is being broken, and then create the smallest
possible test suite that also breaks in a similar way (and post it here)?
In doing all of that, it turned out there was another source module
declaring a test with the same name. And it was that test that overrode
setup and caused the uninitialized references.
--
Darryl L. Pierce, Sr. Software Engineer @ Red Hat, Inc.
Delivering value year after year.
Red Hat ranks #1 in value among software vendors.
http://www.redhat.com/promo/vendor/
4605
days inactive
4606
days old
ruby-sig@lists.fedoraproject.org
2 comments
2 participants
participants (2)
-
Darryl L. Pierce -
Emanuel Rietveld