Hi,
Thanks for the script. It's working. But now I got a new problem. Whenever I
try to create a new virtual machine using either virt-install or
virt-manager I get this error:
Failed to get devices for domain rhel5pv1
libvirt.libvirtError: virDomainCreateLinux() failed
I guess I am doing something wrong in /etc/xen/xend-config.sxp. This is what
I did in it:
(network-script 'network-bridge netdev=dummy0')
The line regarding xenbr0 is commented:
# The bridge is named xenbr0, by default. To rename the bridge, use
#
# (network-script 'network-bridge bridge=xenbr0')
I guess this should bridge xenbr0 via dummy0.
Tell me if I am doing something wrong. One more thing I like to say is that
the doc I pointed out earlier is not perfect. I wrote the script by my hand
and then too it failed with the last 2 errors. Also the lines related on how
to make xenbr0 bridge to dummy0 are not exact if you read them carefully.
Regards
Deependra
On 3/24/07, Andrew Cathrow <acathrow(a)redhat.com> wrote:
I suspect there's a formatting problem - when I tried to copy that script
from the html page it came out a little strange.
Instead of ;; I got . . on one line and , , on the next.
Without seeing your script it's hard to guess - but I'd take a careful
look at the various quote marks and make sure that they are matched.
Here's the script I'm using - it works in a similar vein
You'll need to copy it into /etc/init.d and make sure that it's owned and
readable and executable by root
chkconfig virt-network --add
chkconfig virt-network on
service virt-network start
On Sat, 2007-03-24 at 14:15 +0530, Deependra Shekhawat wrote:
Hello guys,
I am using Redhat Enterprise Linux 5 with Xen. Now I have a laptop on
which RHEL5 is installed. I read the docs related to Xen on redhat's website
where in the troubleshooting section they say to create a dummy0 network
interface and bridge xenbr0 to dummy0 and finally NAT'ing dummy0 so that it
can access the public net.
Well I tried that article and I created a dummy0 interface as told in
there and also bridged dummy0 to xenbr0 in /etc/xen/xend-config.sxp but I
am getting problem in configuring NAT'ing (so that I can access the public
network from within the virtual machine).
I am using the script given here:
https://www.redhat.com/docs/manuals/enterprise/RHEL-5-manual/Virtualizati...
When I run the script I get these two errors:
./S99XenLaptopNAT: line 21: unexpected EOF while looking for matching `"'
./S99XenLaptopNAT: line 24: syntax error: unexpected end of file
Regards
Deependra
--
Enjoy Life !
--Fedora-xen mailing
listFedora-xen@redhat.comhttps://www.redhat.com/mailman/listinfo/fedora-xen
--
Andrew Cathrow
Red Hat, Inc.
(678) 733 0452 - Mobile
(404) 437 6178 - Home Office
acathrow(a)redhat.com
--
Enjoy Life !