Thanks for the respones. I gave it a try but was not able to have any luck. To give you
some more details I am trying to run this system with a continues wave YAG laser. I have
the correction file set to the one you just gave me and the firmware pointing to the
RTC3D2.hex file in RTC files folder form the drives download from the Scanlab site. I also
have updated the firmware to make sure it is up to date. The error I get almost right
after hiting the mark button is
"ScanLAB(R) RTC:
Could not allocate required resources!"
Thanks again for the help
Jacob
________________________________________
From: openapc-bounces(a)lists.fedorahosted.org [openapc-bounces(a)lists.fedorahosted.org] on
behalf of Miguel [miguel67(a)gmx.de]
Sent: Tuesday, July 31, 2012 3:41 PM
To: openapc(a)lists.fedorahosted.org
Subject: Re: RTC setup question
I forgot: here are one correction file who works
Miguel Abril
From: Banasek, Jacob Thomas<mailto:banasek.2@wright.edu>
Sent: Tuesday, July 31, 2012 8:05 PM
To: openapc@lists.fedorahosted.org<mailto:openapc@lists.fedorahosted.org>
Subject: RTC setup question
I just found this software and trying to connect on the BeamConstruct software to an RTC 3
card. I think I have it set up to the correct files (and have tried many different
things), but am continually getting "cannot allocate required resources" as an
error whenever I try to run a pattern. I think it is connection to the software problem
as this card does work with a different program that was being used). I was wondering if
anyone had any tips, tricks, or suggestion on how to get this to work.
thanks for your time and help
jacob
________________________________
_______________________________________________
openapc mailing list
openapc(a)lists.fedorahosted.org
https://lists.fedorahosted.org/mailman/listinfo/openapc