Hi,
I've just released system-config-printer-1.3.3. Here are the changes
compared to 1.3.2:
Main application:
* Set translation domain for ServerSettingsDialog (Ubuntu #777188).
* scp-dbus-service: Ignore setlocale() errors (Ubuntu #748964).
* Renamed ui/*.glade to ui/*.ui again (Ubuntu #759811).
* Allow % character in SMB URI (Ubuntu #747400).
* More error handling (Ubuntu #744783).
* Avoid traceback if printer duplication fails (bug #694629).
* Fixed off-by-one error in monitor.
* Fixed printer renaming (Ubuntu #726954).
Printer Properties dialog:
* Added PrinterModified D-Bus signal to printer properties interface.
* More robustness for printer properties dialog when printer removed
(Ubuntu #741987).
New Printer dialog:
* Fixed PPDs loader when using CUPS remotely or when DBus not available
(bug #693515).
* Handle failure to load PPDs more gracefully (Ubuntu #742409).
* Avoid traceback when cancelling New Printer dialog after failure.
* Make sure everything is ready before handlers might be called (bug
#689336).
Job Viewer:
* Ensure consistency in jobviewer if add_job fails (bug #693055, bug
#632551).
* Be defensive against CUPS returning incorrect job IDs (Ubuntu
#721051).
* Job viewer's attribute window: Convert job numbers and attribute
values to strings (Ubuntu bug #733088).
Other bits:
* More uses of check-device-ids.py.
* udev-configure-printer: be more defensive when parsing CUPS response
(Ubuntu #760661).
http://cyberelk.net/tim/data/system-config-printer/1.3/
Tim.
*/