Hi, on a up to date FC5 host, with 3 network card, if I load the eth2
first of eth1 or eth0 the network interface eth2 is not created:
[root@cambiami ~]# service network stop
Arresto dell'interfaccia di loopback: [ OK ]
[root@cambiami ~]# grep eth /etc/modprobe.conf
alias eth0 r8169
alias eth1 natsemi
alias eth2 natsemi
[root@cambiami ~]# rmmod r8169 natsemi
[root@cambiami ~]# rmmod r8169 natsemi
ERROR: Module r8169 does not exist in /proc/modules
ERROR: Module natsemi does not exist in /proc/modules
[root@cambiami ~]# ip a
1: lo: <LOOPBACK> mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
5: sit0: <NOARP> mtu 1480 qdisc noop
link/sit 0.0.0.0 brd 0.0.0.0
[root@cambiami ~]# modprobe -v eth2
insmod /lib/modules/2.6.17-1.2157_FC5/kernel/drivers/net/natsemi.ko
[root@cambiami ~]# lsmod |grep -E '(r8169|natsemi)'
natsemi 28193 0
[root@cambiami ~]# ip a
1: lo: <LOOPBACK> mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
5: sit0: <NOARP> mtu 1480 qdisc noop
link/sit 0.0.0.0 brd 0.0.0.0
18: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 1000
link/ether 00:09:5b:1c:9d:97 brd ff:ff:ff:ff:ff:ff
19: eth1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 1000
link/ether 00:40:f4:5f:8e:d1 brd ff:ff:ff:ff:ff:ff
[root@cambiami ~]#
In this example, the only network card connect to the network
is the eth0 (r8169), eth1 and eth2 there are not connect
to the network.
How to I can resolve this issue?
I must load the interface in the order that I want.
With previous FC version this was possible.
Many thanks for your suggestions!
--
Dario Lesca <d.lesca(a)solinos.it>