Nicolas Chauvet kwizart@gmail.com writes:
2016-03-03 21:51 GMT+01:00 Derek Atkins warlord@mit.edu:
Hi, I'm trying to run F23 on a Wandboard Quad, but it's not booting. It hangs after the "Starting kernel" output. I followed the instructions at https://fedoraproject.org/wiki/Architectures/ARM/F23/Installation#For_the_Wandboard_.28Freescale_i.MX6.29 starting from Fedora-Minimal-armhfp-23-10-sda.raw.xz I installed the
If you are on serial you might need to add console=ttymxc0,115200 to the kernel bootlinux in extlinux.conf I never tried to boot using hdmi output, so I usually need to add console there.
Aha. Thank you. This is exactly what I needed.
I didn't see this anywhere on the F23 wiki page, and I didn't need it for F22, 21, or 20, so this IS a change in default behavior. Perhaps this suggestion should be added somewhere on the wiki:
https://fedoraproject.org/wiki/Architectures/ARM/F23/Installation
Nicolas (kwizart)
-derek