[fedora-arm] Logging in after an install

I put it aside for a few months, but I picked up my attempt to get Fedora up and running on a PI 3B. I used arm-image-installer to install the F32 image I prepared: fedora-arm-image-installer --image=Fedora-Workstation-32-1.6.aarch64.raw.xz --media=/dev/sdc --target=rpi3 --resizefs --norootpass The PI boots up until the message, this is the last message that appears on the console: fb0: switching to vc4drmfb from EFI VGA No more messages appear, no console login. But there is apparently a new DHCP assignment on my network. However ssh-ing to that IP address prompts for the root password, and it does not accept an empty password. I suppose I could pull the SD card out, mount it, and copy over an ssh into /root, but what exactly did --norootpass do, and what about not being able to log in through the console? I didn't have a keyboard attached yet, I would think I'd get at least a prompt.