QLogic HBA and max_luns

hello, fedora-list. 1. I have Fedora Core (2.6.11-1.1369_FC4smp) installed from scratch. 2. I have QLogic HBA QLA2340 (new BIOS installed) 3. I have Hitachi RAID with 3 LUNs on it Here is my /etc/modprobe.conf alias scsi_hostadapter sata_sil alias eth0 e1000 alias eth1 e1000 alias scsi_hostadapter1 qla2300 alias usb-controller uhci-hcd options scsi_mod max_luns=8 mkinitrd is done Here is my /etc/grub.conf title Fedora Core (2.6.11-1.1369_FC4smp) root (hd0,0) kernel /vmlinuz-2.6.11-1.1369_FC4smp ro root=LABEL=/1 max_luns=8 initrd /initrd-2.6.11-1.1369_FC4smp.img Here is my dmesg output -----------dmesg output ------------------------------------------ QLogic Fibre Channel HBA Driver ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 48 (level, low) -> IRQ 193 qla2300 0000:02:01.0: Found an ISP2312, irq 193, iobase 0xf8820000 scsi4 : qla2xxx qla2300 0000:02:01.0: Configuring PCI space... qla2300 0000:02:01.0: Configure NVRAM parameters... qla2300 0000:02:01.0: Verifying loaded RISC code... qla2300 0000:02:01.0: Waiting for LIP to complete... qla2300 0000:02:01.0: LOOP UP detected (2 Gbps). qla2300 0000:02:01.0: Topology - (F_Port), Host Loop address 0xffff qla2300 0000:02:01.0: QLogic Fibre Channel HBA Driver: 8.00.02b5-k QLogic QLA2340 - ISP2312: PCI-X (133 MHz) @ 0000:02:01.0 hdma+, host#=4, fw=3.03.08 IPX Vendor: HITACHI Model: DF600F Rev: 0000 Type: Direct-Access ANSI SCSI revision: 03 SCSI device sdb: 734005248 512-byte hdwr sectors (375811 MB) SCSI device sdb: drive cache: write through SCSI device sdb: 734005248 512-byte hdwr sectors (375811 MB) SCSI device sdb: drive cache: write through sdb: sdb1 sdb2 sdb3 Attached scsi disk sdb at scsi4, channel 0, id 0, lun 0 scsi: host 4 channel 0 id 0 lun1 has a LUN larger than allowed by the host adapter scsi: host 4 channel 0 id 0 lun2 has a LUN larger than allowed by the host adapter ----------end of dmesg output -------------------- when I try to run this command - it do HOTHING echo "scsi add-single-device 4 0 0 1" > /proc/scsi/scsi echo "scsi add-single-device 4 0 0 2" > /proc/scsi/scsi I can not find 2 other LUNs (1 and 2). What's wrong with me? It's funny - but then I try to install Win2k (only for test!!!) it seems to work. It found all LUNs - so configurations of Hitachi and HBA are correct. -- WBR, Karasiov mailto:karasiov@infobox.ru