Re: [3dprinting] Re: Where's the best place to discuss Cura issues?

On 12/1/20 9:49 PM, Fulko Hew wrote: > > > On Tue, Dec 1, 2020 at 3:36 PM Miro Hrončok <mhroncok(a)redhat.com > <mailto:mhroncok@redhat.com>> wrote: > > On 12/1/20 8:34 PM, Fulko Hew wrote: > > As the subject line asks, where's the best place to discuss issues? > > The 3dprinting list ? > > Yes, 3dprinting(a)lists.fedoraproject.org > <mailto:3dprinting@lists.fedoraproject.org> > > > In the meantime, I've been using the released version of Cura on F28 > > but I couldn't seem to get a slice that had 1 layer wide vertical walls. > > So I thought I'd try the most recent version in F33 in a VM. > > [I then had to upgrade a system to F33 rather than in a VM.] > > After installing 'dnf install cura' and running it, > > it hangs with a splash screen that says: > > 'Welcome to Ultimaker Cura. > > Please follow these steps to set up Ultimaker Cura. > > This will only take a few moments.' > > > > And that's it. It does nothing else, and there isn't anything I can > click on to > > proceed. > > > > Any suggestions? > > No idea. What virtualization do you use? I've just tried Fedora 33 Workstation > in GNOME Boxes (Running on Fedora 33 Xfce Spin) and it worked for me. > > > I ended up installing F33 on raw hardware (no VM) > and that's what I'm using now. > > There is a "Get started" button under the "...This will only take a few > moments." text. Maybe the VM screen is too small to make it visible, the window > is rather tall. > > > Not on my machine. Try this: https://github.com/Ultimaker/Cura/issues/6058#issuecomment-587093671